Steamfast SF-294 Use and Care Manual download pdf (Page 4)

STEAM MOP SETUP

EXTENSION POLE

1. Insert threaded connector on bottom of Extension Pole into pole base on main unit

(FIGURE 1-A).

2. Rotate Extension Pole in a clockwise direction as shown to screw it into pole base

(FIGURE 1-B). Make sure Pole is tightly secured to main unit.

3. To adjust length of Extension Pole:

A) Rotate upper (thicker) section of Extension Pole in “UNLOCK” direction indicated on label to

unlock it (FIGURE 1-C).

B) Adjust upper section to desired length (FIGURE 1-D).

C) Rotate upper section of Extension Pole in “LOCK” direction indicated on label to lock it back

in place (FIGURE 1-E).

NOTE: Increasing length of Extension Pole may provide additional leverage for easier,

more effective steam mopping.

Assembling Your

3-in-1 Steam Mop

THREADED

CONNECTOR

UPPER SECTION

POLE

BASE

D EC

FIGURE 1

MOP HEAD

CAUTION: Always allow unit to cool before connecting/disconnecting any accessories.

1. Align Mop Head with main unit as shown (FIGURE 2), so that neck is in line with Steam Nozzle.

2. Slide Mop Head neck into Steam Nozzle, pressing rmly until release button snaps through hole.

3. To remove Mop Head, press rmly on release button while simultaneously pulling Mop Head

away from Steam Nozzle.

MICROFIBER PADS

1. Lay one Microber Pad on at surface, with two fastener strips facing upward.

2. Align Mop Head above Microber Pad. Make sure Mop Head is oriented with Pad as shown,

and centered as best as possible (FIGURE 3-A).

3. Press Mop Head rmly down onto Microber Pad. Fastener strips will adhere to pad grips on

underside of Mop Head. Pad should now be attached and ready for use (FIGURE 3-B).

CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.

NOTE: Microber Pads are machine washable. To avoid picking up lint, washing

separately from other fabrics is recommended. Only use liquid detergent. Avoid using

any fabric softeners or bleach. Air drying is recommended; machine drying on a low

setting is acceptable as well.

STEAM

NOZZLE

RELEASE

BUTTON

HOLE

MOP

HEAD

NECK

FIGURE 3

FIGURE 2

A B

ENGLISH ENGLISH

1 2 3 4 5 6 7 8 9 ... 28 29

Comments to this Manuals

No comments

Steamfast SF-294 Use and Care Manual Page 4

Comments to this Manuals